albertshaw

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 35 total)
  • Author
    Posts
  • in reply to: Garage door problems #269032
    albertshaw
    Participant

    Probably the electric eye sensor is blocked, fallen off, etc. So the door thinks a person is under it. If it goes down, it will hurt someone. So it won’t go.

    On my door, the only way to close is to hold the button down continuously until it is completely closed. Of course, it is best just to reconnect the electric eye thing.

    in reply to: Emulate #268577
    albertshaw
    Participant

    That was funny. Of course, I would if I could afford it.

    I am waiting till next year. Just got the house and have to hold down expenses until thing are settled and furniture is bought.

    Although now that I’ve been doing it for a while, blowing leaves is sort of fun.

    in reply to: The east coast was sure a surprise for me #268470
    albertshaw
    Participant

    Thank you for your reply. I forgot to say it in the last message.

    in reply to: Blower #268469
    albertshaw
    Participant

    We had a lot of rain on the NE coast – as you probably seen on TV.

    I just put on a light synthetic sweater, sandles and turn on my hand held leaf blowers and blow and mow in the rain. I own a middle of the pack (not the most powerful) but solid leaf blower. I just use it on the wet grass/leaves. When there are grass to be cut, I blow the leaves away from the shrubs then mow the whole lawn to suck up the leaves.

    One of my neighbor has this real powerful blower with wheels and a backpack blower and he blows all the leaves onto the street without bagging. The other neighbor uses a lawn service. The third neighbor rakes onto a sheet but he has a small lawn.

    So we are all different, and since this is the first time I own a house with falling leaves, I don’t have a neighbor to emulate.

    Hence all the questions.

    in reply to: What My Neighbor Does….. #268149
    albertshaw
    Participant

    I pretty much mastered the other tools, lawnmower and blower.

    This string trimmer is proving difficult. And I grew up using an electric string trimmer and I never had any problems.

    I’ll give it a try again.

    Thanks

    in reply to: closet auger #267434
    albertshaw
    Participant

    It may take hundreds of gallons of water to dissolve the soap. Hopefully, after a day of soaking, it will get softer and flush easier.

    I got a worm thing at home depot for $30 or so. Works well. I think there are cheaper units available.

    in reply to: replacing old thermostat #265554
    albertshaw
    Participant

    I agree – go for it.

    Just sharing my experience here. Everyone in my house is very energy cost concious. We turn on the heat or AC when we use a zone and turn it off when we get out of a zone. On leaving the house, we remember to turn off all heat and AC. Or leave the heat at say 60 degrees.

    The AC/heat stays on at night but at a minimal setting.

    Never felt the need to use the automatic thermostat. So in my case, there wound be little or no money saved. But every household is different.

    in reply to: My 2 Cents….. #265251
    albertshaw
    Participant

    I see, turn down the blower as the pile gets bigger. OK.

    Thanks for the other advice on where to aim.

    I’ll go and give it a try.

    in reply to: Nothing new here… #265177
    albertshaw
    Participant

    Do you have any problems with vibrations making you uncomfortable? Sitting on a 10,000 rpm engine sounds tough for hundreds of miles.

    Sounds like fun.

    in reply to: Horsepower Is Horsepower….. #265147
    albertshaw
    Participant

    Nice bike. I would investigate better brakes as your new performance may really stress out the braking system.

    But nice. Wish I can do that.

    in reply to: Can’t Start Stihl Trimmer #265108
    albertshaw
    Participant

    I’ve own 2. A Ryobi and an Echo. Both start right up.

    Sometimes you can fix the problem. But sometimes, it is just easier to get a new one. Since you just got it – if it does not start, the store has a problem, not you.

    New to the burbs myself.

    in reply to: Protecting New Table #264893
    albertshaw
    Participant

    That’s what I use. With a kid in the house, and crayon, the only finish that can resist is one of those poured acrylic restaurant finishes.

    in reply to: Removing White-Out #264822
    albertshaw
    Participant

    I use a lot of whiteout. Usually, scraping with the fingernail – or some soft plastic – would get it off.

    If you monitor has textured plastic, then hard rubbing with a piece of cloth, water, and a lot of rubbing should get most of it of.

    Whiteout is not made for markings. It is easy to get out. Easier than paint or marker pen.

    in reply to: Materials #264793
    albertshaw
    Participant

    Don’t forget safety equipment

    Goggles
    Hearing protectors
    Extension cords rated for the power tools you pan to use.

    Drywall T square.

    As for closet doors, getting them prehung will save headaches – if you are no good in hanging doors.

    in reply to: Refinish hardwood floor #264649
    albertshaw
    Participant

    I was house hunting and saw a house where someone – who obvioiusly did not know what they were doing – sanded the floor. Gouge marks galore. The floors were stained dark and the marks were clearly visible. You can really mess up the sanding if you are not careful. It was ugly.

    Did not make offer on the house.

Viewing 15 posts - 1 through 15 (of 35 total)