Forum Replies Created
-
Posts
-
Sounds like you lost the power supply to the GE Relays…..
Either the tranformer is shot
OR the Power to the transformer
“……measure Once…..cut Twice….
throw that one away and cut a new one….”Here’s a recent post with contact info:
http://discussions.tommmymac.us/BBS/Carroll_Parts-Parts_Supplies_and_Materials-1-T634.html#634
“……measure Once…..cut Twice….
throw that one away and cut a new one….”Lakewood filed Chapter 7……from their Website RE:Parts…….
http://www.nelsonappliance.com/space+heater+parts.html
“……measure Once…..cut Twice….
throw that one away and cut a new one….”The whole assembly is called a Flush Valve
http://www.toiletology.com/howtofix.shtml
…the “flapper” is part of the flush valve
“……measure Once…..cut Twice….
throw that one away and cut a new one….”Re-read the instructions……checking step #11 in this installation PDF
http://www.fluidmaster.com/html/pdf/400ls_instructions.pdf
“……measure Once…..cut Twice….
throw that one away and cut a new one….”What is Aqua-Board ?
OR is it Aqua-Tile Board ?
Eh ?
“……measure Once…..cut Twice….
throw that one away and cut a new one….”Concrete: sounds like T-u-c-k P-o-i-n-t-i-n-g
ISP suggests Texas
Larry: Brick over what ?….stud wall ?
“……measure Once…..cut Twice….
throw that one away and cut a new one….”Looks like you’re posting from the UK
Most of us are in the USA
Perhaps a “local” forum would be helpful:
“……measure Once…..cut Twice….
throw that one away and cut a new one….”http://www.owwm.com/mfgIndex/pubdetail.aspx?id=621
“……measure Once…..cut Twice….
throw that one away and cut a new one….”A hot air gun (paint remover) or a hot plate will soften the old mastic enough to scrape off using a putty knife……
“……measure Once…..cut Twice….
throw that one away and cut a new one….”You just asked this with answers……
http://discussions.tommmymac.us/wwwboard/messages/324825.html
“……measure Once…..cut Twice….
throw that one away and cut a new one….”The wrong wire is on the “painted”/common terminal……(of the dimmer)….the travelers(2) can land on either of the brass screws
Just try swapping the wire on the common and test again…..a 50/50 chance first try
“……measure Once…..cut Twice….
throw that one away and cut a new one….”A wiring diagram is usually located on the inside of the motor’s electrical cover……
“……measure Once…..cut Twice….
throw that one away and cut a new one….”http://www.simmonskids.com/consumer_service.cfm
“……measure Once…..cut Twice….
throw that one away and cut a new one….”
