[mukhi65]

thanks for reply.
I do have new water mixing valve installed. I did open front control panel and looking for any broken wire or any visiual deffect. I didn’t find any thing.

I was Omeing out temp. selector switch and found open connection for cold cycle. To makesure can you tell me how to Ome it properly. Switch had 6 connector in my model one…
I will give shot at replacing this switch and try to fix it, otherwise i need to purchase new one…It’s so costly…

Thanks again for your time…

[mukhi65]

Here is the model number for my washer…
washer Model # — 11026914690
I also discover problem during rinse cycle.

1)
initial — fill warm water/ no cold one.
2)
spin and drain water
3)change cycle to rinse
No water coming at all.

I hope this will help you to understand my issue..

Thx.

[mukhi65]

I have changed the water mixing valve for my 90 seris washer and it works well for 3-5 load of laundry. Now, again i see problem with cold water side. Any suggestion?

thanks.

[mukhi65]

Thanks again, it works well with hot side and flow very well, Cold one is the problem. I think I will change fill valve on this washer. Do you know what is the best way to open back side? Any drawings?

Thx.

[mukhi65]

Dan O.,

Thank you for writing me back. I found model number for my Kenmore 90 seris washer.

washer Model # — 11026914690
Gas Dryer Model # — 11076914690

I will wait for your response.

[Author]

Posts