Cutting cove moulding on a 43 degree inside corner

[Unregistered-Kurt]

I built a flat panel wall that runs along the staircase in my foyer. I am fitting cove moulding on the styles and rails. I came across an inside corner of a style and rail that follows the stringer and is intersetected by a vertical style. It’s about 42 degrees. I can’t seem to get the correct angle(s) for this inside corner. Any suggestions?

Thanks,

[Sauerkraut57]

This site is good for figuring the angles for doing crown molding. Your problem sounds similiar so try here first:

http://www.josephfusco.org/Articles/Crown_Moulding/crownscript.html

[Author]

Posts