Tommy Mac Discussions › Forums › Fix-it Forum: Home Improvement & Do It Yourself Repair Forum › cast iron bathtub repair › Cast iron tub repair › Cutting cast iron tub › cutting cast iron
December 11, 2004 at 10:51 am
#255560
Unregistered-pjhalick
Guest
I too am searching for a way to quickly cut or break cast iron tubs. Usually I smash them with a sledge hammer. But this is slow and messy. I have not had much luck with a cut off wheel on a high speed grinder. Perhaps a 7″ or gas powered cut off tool (Like the fire the department uses)would be the best. Or maybe an oxy acetylene torch? Any one have any ideas?